ADAS Calibration · Pre & Post-Repair Scans
Scans.
Calibrations.
Confidence.
Today’s vehicles are smarter than ever. After a collision repair, a windshield replacement, a bumper removal or suspension work, those systems may need attention before the vehicle goes back on the road.
Scanned. Calibrated. Verified.
OEM procedures · Static & dynamic · Documented results
What we do
Scan it. Calibrate it. Deliver it with confidence.
Three services that cover the vehicle from the moment it arrives at the shop until it goes back to the customer.
Pre-Repair Scans
We scan the vehicle before repairs begin to identify existing trouble codes, ADAS faults, and other system issues. This gives the shop a clear picture of what’s going on before anything is taken apart.
Request a pre-repair scanPost-Repair Scans
Once repairs are complete, we scan again to check for faults, verify repairs, and help make sure the vehicle’s electronic systems are communicating properly before delivery.
Request a post-repair scanADAS Calibrations
We perform calibrations for many of the safety and driver-assistance systems found in today’s vehicles, following the manufacturer’s procedure for each one.
Request an ADAS calibration
ADAS calibrations
We calibrate many of today’s systems, including:
- Forward-Facing Camera Calibration
- Radar Calibration
- Blind Spot Monitor Calibration
- Lane Departure / Lane Keep Assist
- Adaptive Cruise Control
- Forward Collision Warning
- Automatic Emergency Braking
- Surround View / 360° Camera Systems
- Parking Sensors & Parking Assist
- Steering Angle Sensor Calibration
- Occupant Classification / Seat Weight Systems
- Other OEM-Required ADAS Calibrations
Static + dynamic calibrations
We follow the vehicle’s requirements, not a one-size-fits-all approach.
Depending on the manufacturer and vehicle, a calibration may need stationary targets in a controlled environment, a specific road-driving procedure, or sometimes both.
Controlled-environment calibration
The vehicle is positioned in our bay and aligned to OEM-specified targets using a calibration frame, with measurements taken to the manufacturer’s specs.
Road-driving procedure
Some systems finish calibrating on the road. We complete the manufacturer’s driving procedure under the conditions it requires and confirm the system is ready.
When might a vehicle need calibration?
It’s not always obvious.
Calibration may be required after any of these. Even when a sensor wasn’t directly damaged, its position or aiming can be affected during a repair.
- Collision repairs
- Windshield replacement
- Bumper removal / replacement
- Camera or radar replacement
- Suspension repairs
- Wheel alignment
- Ride-height changes
- Structural repairs
- Certain ADAS-related DTCs
Built for body shops
We know what matters in a collision shop.
North Shore Calibration Services helps take the calibration process off your plate so your team can focus on the repair.
-
Accurate work
Calibrations performed to the vehicle’s requirements, not a one-size-fits-all approach.
-
Proper documentation
Scan and calibration records you can keep with the repair file.
-
Quick communication
Clear answers on what the vehicle needs and when it will be ready.
-
Back to the customer
We take calibration off your plate so your team can focus on the repair.
Have a vehicle you’re not sure needs calibration?
Give us a call or send a WhatsApp message. We’ll help you figure it out.
Contact
Schedule a scan or calibration.
Tell us about the vehicle and the repair. We’ll confirm what it needs and get it on the schedule. Prefer WhatsApp? Fill in the form and tap “Send by WhatsApp”, then attach estimates or photos in the chat.
-
Call (978) 555-0100
-
WhatsApp (978) 555-0101
-
Service area Serving the North Shore and surrounding areas